TotalBoat Inflatable Boat Paint

Medium copper load helps prevent marine growth on inflatable boats

Flexible coating resists cracking, chipping, and peeling

Low VOCs with easy soap & water cleanup

Available in Gray

TotalBoat Inflatable Boat Paint is a water-based ablative antifouling paint designed for PVC, Hypalon®, rubber inflatable boats, and properly prepared fiberglass or aluminum. This flexible coating won't crack or flake when rolled up and provides reliable protection against barnacles and marine growth.

Product Overview

• Cleanup: Water
• Thinner/Reducer: Water
• Surface Preparation Solvents:
  • TotalBoat Dewaxer & Surface Prep (fiberglass)
  • TotalBoat Epoxy Primer Thinner 200 (Hypalon®, PVC, rubber)
• Primers: TotalBoat TotalProtect, TotalBoat Aluminum Boat Barrier Coat
• Acceptable Substrates: Hypalon®, PVC, rubber, fiberglass, aluminum (must be primed), and properly prepared previously painted substrates
• Available Colors: Gray

Surface Preparation

Hypalon®, PVC, or Rubber Inflatable Surfaces

• Wash with warm water and mild soap. Dry completely.
• Mask off area to be painted.
• Scrub thoroughly with a bronze wool pad dipped in TotalBoat Epoxy Primer Thinner 200.
• Wipe clean and allow to dry for one hour.
• Apply Inflatable Boat Paint.

Bare Fiberglass or Gelcoat

• Allow substrate to cure 5–7 days.
• Remove wax or amine blush.
• Wash, dry, and dewax using TotalBoat Dewaxer & Surface Prep.
• Sand with 80-grit to a dull finish.
• Clean and allow to dry completely.

Barrier Coat Application:

• Fiberglass: Apply TotalBoat TotalProtect
• Aluminum: Apply TotalBoat Aluminum Boat Barrier Coat

Previously Painted Surfaces

• Only apply to compatible coatings in good condition.
• Not compatible with tin, vinyl, or Teflon® paints.
• Sand and clean using TotalBoat Dewaxer & Surface Prep.

Aluminum

• Cannot be applied directly.
• Must be primed with TotalBoat Aluminum Boat Barrier Coat.

Application Over Barrier Coats

• Apply after barrier coat cures at least 4 hours.
• Thumbprint method is NOT recommended.

Sanding Method

• Wait 24 hours, sand with 80-grit, clean, and apply.

Application Conditions

• 50–90°F and under 90% humidity
• Avoid direct sunlight and moisture

Application Methods

• Apply 1–2 coats per season
• Apply extra coat in high-chafe areas
• Apply at 3.5–4 mils wet film thickness

Dry Time Between Coats

• 1.5 hours @ 90°F
• 3 hours @ 70°F
• 6 hours @ 50°F

Dry Time to Launch

• 6 hours @ 90°F
• 10 hours @ 70°F
• 16 hours @ 50°F

Brushing/Rolling Instructions

• No thinning typically required
• If needed, thin 5–10% with water
• Use chip brushes and 3/16" rollers

Spraying Instructions

• Thin 5–10% with water
• Recommended nozzle size: 1.8–2mm

Maintenance

Check regularly for buildup. Clean with a sponge or soft abrasive pad as needed. Best performance occurs with regular use.

Warning

RAGS, STEEL WOOL, OR WASTE-SOAKED MATERIALS MAY SPONTANEOUSLY CATCH FIRE IF DISCARDED IMPROPERLY.

Personal Safety

Always use proper PPE and ensure adequate ventilation.

Application Data

Physical Data