TotalBoat Aluminum Boat Etch Wash

Cleans and etches aluminum for improved coating adhesion

Removes corrosion and oxidation

Prepares aluminum for paint, primer, epoxy, or polishing

TotalBoat Aluminum Boat Etch Wash cleans, brightens, and improves the adhesion of coatings applied to aluminum, galvanized steel, and other non-ferrous metals. A single application removes corrosion and etches the surface so finishes bond more effectively and last longer. It is compatible with one- and two-part finishes and may be used above or below the waterline.

Substrates

• Aluminum
• Galvanized steel
• Other non-ferrous metals

Surface Preparation

• Remove loose dirt or debris from the surface
• Abrade surface with a Scotch-Brite pad or sand with 220-grit sandpaper
• Remove sanding residue completely

Application

• Product is ready to use
• Apply by brush or spray
• Lightly abrade areas with oxidation buildup if needed
• Allow product to remain on surface for 5 minutes
• Do not allow product to dry on the surface
• Reapply as needed to keep surface wet during application
• After 5 minutes, rinse thoroughly with fresh or deionized water
• Dry surface completely
• Apply paint, primer, epoxy, or polish immediately after drying

Application Notes

• Do not allow product to dry on metal during application
• Reapply as needed to maintain a wet surface
• Immediate coating after drying provides best adhesion

Cleanup

• Water

Personal Safety

• Avoid bodily contact with product
• Use apron, rubber gloves, and goggles

Application Data

Physical Data

Frequently Asked Questions